We recommend washing your wig or hairpiece every 6-8 wears
CLEANSE & CONDITION
- Before washing your HD wig or hairpiece, gently remove any tangles with your Jon Renau wide tooth comb ONLY
- Hold wig or hairpiece under cool running water.
- Gently lather the hair with a capful of Shampoo while making sure that the hair is traveling in the same direction. DO NOT rub hair as this may cause tangling.
- Rinse thoroughly with cool water until water runs clear.
- Wrap wig or hairpiece in a towel and gently pat dry.
- Gently detangle hair using your Jon Renau wide tooth comb.
- Spray with Leave-In Conditioning Spray (3-5 pumps) keeping away from base of wig or hairpiece.
DRY & STYLE
- Air drying your wig will give the best results. You can gently blow dry (low-medium heat) using ONLY your Jon Renau wide tooth comb.
- Apply HD Smooth Detangling Spray, (3-5 pumps) focusing on the bottom half of wig or hairpiece. Gently comb through again with your Jon Renau wide tooth comb.
- We recommend that ONLY the Jon Renau wide tooth comb is used on your HD wig or hairpiece. Other tools will cause frizzing/tangling.
- HD Fiber can withstand heat tools up to 350° F, however, Jon Renau recommends working at 270°-280° F.
- It is recommended to use professional grade heat styling tools with digital temperature settings to control heat.
CURL HD FIBER
- Heat your curling iron to 270°-280°F.
- Using your Jon Renau wide tooth comb, gently comb hair free of tangles.
- Starting at the nape, take ½ inch-1.5 inch sections of hair (Smaller sections=tighter curls, larger sections=looser curls)
- Spray Heat Treat Thermal Spray on the section to protect the fiber (1-2 pumps per section)
- Gather hair into curling iron, smooth through to the ends. Roll iron up towards base of wig or hairpiece, staying 1-2 inches away
- Hold for 10-15 seconds, then turn the tip of iron toward the ground and release curl into palm of hand
- Holding curl in one hand, gather up towards base and secure curl with a small metal clip (like a pin curl)
- Allow curl to cool completely (about 5 minutes); remove clip and let curl hang naturally
- Hair can be combed with your Jon Renau wide tooth comb(or fingers for best results) to blend curls
FLAT IRON
- Heat your flat iron to 270°-280°F
- Starting at the nape, take ½ inch-1.5 inch sections
- Spray Heat Treat Thermal Spray on the section to protect the fiber (1-2 pumps per section)
- Staying at least 1-2 inches away from base, slowly smooth flat iron down through ends
- Keep hair smooth by following behind the flat iron with your Jon Renau wide tooth comb
- Allow hair to hang naturally and cool completely
TIPS
- We highly recommend using HD Smooth Detangling Spray with a Jon Renau wide tooth comb DAILY to detangle your HD wig. This is especially important with the mid-length to long length HD wigs or hairpieces
- We offer HD Smooth in a convenient 2oz. size for travel
- Allow your HD wig to air dry naturally instead of blow drying to help maintain the integrity of the fiber
- Help protect the fiber against heat damage by using Heat Treat Thermal Spray when using heat styling tools
|
|
|
|
|
|
|
|
|
|
